Before you buy a spot free water system for detailing, there is one number you should know: the TDS of your tap water. It takes about a minute to check, and it tells you how hard your system will have to work and what it will cost you to run.
What TDS Means
TDS stands for Total Dissolved Solids. It is the amount of dissolved minerals and other material in your water, such as calcium, magnesium, iron and sodium, measured in parts per million (PPM). When water evaporates off your paint, these solids stay behind as white spots and rings. Spot free water is water with almost none of them left.
How to Test Your Tap Water
- Get a handheld TDS meter. They are inexpensive and easy to find.
- Run the outdoor spigot you plan to use for a few seconds, so you are not testing water that has been sitting in the line.
- Fill a clean cup, dip the meter in, and read the number in PPM.
- Write it down. Test again at the other places you wash, since the water can differ from one location to another.
What Your Reading Means for Your System
Every dissolved mineral a DI filter removes uses up a little of its resin. So the higher your tap water TDS, the faster the resin is used up. Tap water in the hundreds of PPM, such as 400, means a DI filter on its own is doing all of the work by itself, and you will be buying and swapping resin often.
A reverse osmosis (RO) stage in front of the DI filter removes most of the dissolved solids first, typically 90 to 98 percent. The resin only has to polish what is left, so it lasts far longer. If your reading is high, adding RO is usually cheaper over time than replacing resin again and again.
Check Your System Too: Before and After
A TDS meter is not only for testing tap water. Fresh DI resin should read 0 PPM at the outlet. When the reading climbs above zero, the resin is wearing out and spots can start to appear. A dual inline tester reads the water before and after your filter, so you can watch it while you work and change the resin at the right time, not too early and not too late.
Not Sure What Your Number Means?
Send us your reading and tell us how you plan to use the water, and we will help you choose a setup. We are working detailers who build RO/DI systems and ship them nationwide. See our spot free water systems for detailers, read why DI-only setups keep running out of resin, or call 904-465-6312 for a free consultation.
Related reading: how to get spot free water for car detailing: DI filter vs. RO/DI.
